When using the advanced wall function there are options to manipulate your zone as you see fit.
To use these tools please follow the below steps.
1. Select one wall
2. Go to Insert Coverings Advanced Wall
3. Click new
4. Set the position of your zone by clicking on the drop down arrow under the top and bottom height
5. Note that there are a few other ways to add in a zone by clicking on the drop down arrow under new
6. Under the Tools section there are 6 options:
Double Cut by clicking in the corner of your zone and dragging you can achieve something like the below
Triple Cut If you select either the top or bottom point you can achieve something like the below
Split Edge this works in the same fashion as edit worktops and allows you to split an edge if you wish
Merge Edge use this to merge any edges you need to
Stretch Edge again this works the same way as editing worktops, thus letting you stretch an edge if needed
Corner Cut This is also available in edit worktops too and lets you achieve something like the below by clicking on the corner points
Be aware that you can use the x and y offsets too as you would with edit worktops when using any of these tools
7. When you are happy with your zone click confirm
Related articles
How to Tile Multiple Walls in 2020 Fusion
Using the Advanced Wall Covering Tools
